SpECseal Primer 25

SpECseal Primer 25 is use when preparing porous surfaces such as concrete, brickwork, stonework, asbestos and timber and non-porous surfaces such as stainless steel and ceramics.

Surface preparation
Joint surfaces to be primed must be completely dry and free from all dirt, dust, cement laitance and other loose and deleterious matter. This is best achieved by grit or sand blasting or thorough wire brushing and then blowing clean with oil free compressed air prior to the installation of backer rod or bond breaker tape.

Mixing
SpECseal Primer 25 is a two component primer. The base and hardener components should be mixed together for 2 minutes to produce a uniform consistency.

Application
The primer should be applied to clean, dry surfaces prior to the installation of backer rod or bond breaker tape. The freshly mixed SpECseal 625 should be applied after the primer solvent has been released and when it is just touch dry. The sealant should be applied ½ – 2½ hours after priming.

If the primer is left to dry longer than 2½ hours the surfaces must be re-primed prior to applying the sealant. Allow to become tacky before installing SpECseal 625.